emccalib - Adjust ini tuning variables on the fly with save option
emccalib.tcl [options]
The Calibration assistant. This tool Reads the HAL file and for every setp that uses a variable from the INI file that is in an [AXIS_L], [JOINT_N], [SPINDLE_S], or [TUNE] section it creates an entry that can be edited and tested.
The calibration/tuning tool supports the following stanzas:
[JOINT_N], [AXIS_L], [SPINDLE_S], [TUNE]
where N is a joint number (0 .. ([KINS]JOINTS-1) ), L is an axis coordinate letter (X,Y,Z,A,B,C,U,V,W), and S is a spindle number (0 .. 9).
Note
The number of allowed spindles is 8 but legacy
configurations may include a stanza [SPINDLE_9] unrelated to
an actual spindle number.
Note
The [TUNE] stanza may be used for specifying tunable items
not relevant to the other supported stanzas.
Return exit code 1 if the ini file is incompatible with the current version of emccalib.
linuxcnc(1)
Original version by Petter Reinholdtsen as part of the LinuxCNC project. Improvements by several other members of the LinuxCNC development team.
This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.