CLASSICLADDER

NAME
SYNOPSIS
DESCRIPTION
PINS
PARAMETERS
FUNCTIONS
BUGS
SEE ALSO

NAME

classicladder - realtime software plc based on ladder logic

SYNOPSIS

loadrt classicladder_rt [numRungs=N] [numBits=N] [numWords=N] [numTimers=N] [numMonostables=N] [numCounters=N] [numPhysInputs=N] [numPhysOutputs=N] [numArithmExpr=N] [numSections=N] [numSymbols=N] [numS32in=N] [numS32out=N] [numFloatIn=N] [numFloatOut=N]

DESCRIPTION

These pins and parameters are created by the realtime classicladder_rt module. Each period (minimum 1000000 ns), classicladder reads the inputs, evaluates the ladder logic defined in the GUI, and then writes the outputs.

PINS

classicladder.0.in-NN IN bit

These bit signal pins map to %INN variables in classicladder

classicladder.0.out-NN OUT bit

These bit signal pins map to %QNN variables in classicladder Output from classicladder

classicladder.0.s32in-NN IN s32

Integer input from classicladder These s32 signal pins map to %IWNN variables in classicladder

classicladder.0.s32out-NN OUT s32

Integer output from classicladder These s32 signal pins map to %QWNN variables in classicladder

classicladder.0.floatin-NN IN float

Integer input from classicladder These float signal pins map to %IFNN variables in classicladder These are truncated to S32 values internally. eg 7.5 will be 7

classicladder.0.floatout-NN OUT float

Float output from classicladder These float signal pins map to %QFNN variables in classicladder

classicladder.0.hide_gui IN bit

This bit pin hides the classicladder window, while still having the userspace code run. This is usually desirable when modbus is used, as modbus requires the userspace code to run.

PARAMETERS

classicladder.0.refresh.time RO s32

Tells you how long the last refresh took

classicladder.0.refresh.tmax RW s32

Tells you how long the longest refresh took

classicladder.0.ladder-state RO s32

Tells you if the program is running or not

FUNCTIONS

classicladder.0.refresh FP

The rung update rate. Add this to the servo thread. You can added it to a faster thread but it Will update no faster than once every 1 millisecond (1000000 ns).

BUGS

See http://wiki.linuxcnc.org/cgi-bin/wiki.pl?ClassicLadder_Ver_7.124 for the latest.

SEE ALSO

Classicladder chapters in the LinuxCNC documentation for a full description of the Classicladder syntax and examples

http://wiki.linuxcnc.org/cgi-bin/wiki.pl?ClassicLadder_Ver_7.124