mdi - Send G-code commands from the terminal to the running LinuxCNC instance
mdi
mdi sends G-code commands to LinuxCNC. The command starts an envirmonemt in which G-code commands are sent to the interpreter and machine feedback is displayed.
send a single
command and exit
mdi m2 s1400
interactive
session
$mdi
MDI> m3 s1000
MDI> G0 X100
MDI> ^Z
$stopped
LinuxCNC(1)
Much more information about LinuxCNC and HAL is available in the LinuxCNC and HAL User Manuals, found at /usr/share/doc/LinuxCNC/.
None known at this time.
This man page written by andypugh, as part of the LinuxCNC project.
Report bugs at https://github.com/LinuxCNC/linuxcnc/issues
Copyright
© 2020 andypugh.
This is free software; see the source for copying
conditions. There is NO warranty; not even for
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.