NEWS
LinuxCNC 2.5.2 Release
There are no translations available.

LinuxCNC 2.5.2 Update Released (changelog).
 
LinuxCNC 2.5.1 Release
There are no translations available.

LinuxCNC 2.5.1 Update Released (changelog). If the Package Manager does not prompt you to upgrade see this page.
 
LinuxCNC 2.5.0 Release
There are no translations available.

New major release (changelog). See the instructions to update your system from EMC 2.4 to LinuxCNC 2.5.
 
Home Forum Configuring LinuxCNC PnCConf Wizard Forward btn on Axis config stays gray

Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: Forward btn on Axis config stays gray

Re:Forward btn on Axis config stays gray 11 Dez 2011 21:52 #15582

  • cmorley
  • cmorley's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1488
  • Thank you received: 40
  • Karma: 89
Ahh yes I found the problem currently PNCconf does not allow a scale less then 1.
I will fix this soon.
thank you for the feedback.
The administrator has disabled public write access.

Re:Forward btn on Axis config stays gray 11 Dez 2011 22:00 #15583

  • cmorley
  • cmorley's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1488
  • Thank you received: 40
  • Karma: 89
Does a scale of .111 make sense?
please explain your A axis motor and gear ratios.
Last Edit: 11 Dez 2011 22:00 by cmorley.
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: cmorley
Time to create page: 1.124 seconds
Powered by Kunena Forum
© 2013 LinuxCNC.org
Joomla! is Free Software released under the GNU General Public License.