from anilam to emc2?

More
06 Jan 2013 16:27 #28407 by Rick G
Replied by Rick G on topic Re:from anilam to emc2?
Well that got put on the back burner for now, never got past the theoretical stage, perhaps later.
So yes start a new thread and good luck.

Rick G

Please Log in or Create an account to join the conversation.

More
06 Jan 2013 21:59 - 07 Jan 2013 01:20 #28414 by BigJohnT
Replied by BigJohnT on topic Re:from anilam to emc2?
As it turns out the fellow that started this thread tried to use Mach but never could get it to work.

John
Last edit: 07 Jan 2013 01:20 by BigJohnT.

Please Log in or Create an account to join the conversation.

More
07 Jan 2013 01:16 #28421 by andypugh
Replied by andypugh on topic Re:from anilam to emc2?

As it turns out the fellow that started this thread tried to use Mach but never could get it to work.


Actually, I emailed him and he now has it working nicely on Mach3.
I think he had to buy quite a lot of different hardware.
He was told by guys on the Mach forums that the conversion would take 2 weeks. I told him that for a LinuxCNC conversion (from scratch, first conversion) he should expect it to take 3 months.
So he went with Mach….
It took a year.

Please Log in or Create an account to join the conversation.

More
07 Jan 2013 05:25 #28423 by ryankracht
Replied by ryankracht on topic Re:from anilam to emc2?
Thanks. all.

I started a new thread:

here

Please Log in or Create an account to join the conversation.

Moderators: cncbasher
Time to create page: 0.138 seconds
Powered by Kunena Forum