Moschip MCS9815CV + BAR error updating

More
10 Sep 2014 20:31 #51028 by ChrisB
Hallo,
i have installed LinuxCNC with the LiveCD.
Motherboard: Asus a8nsli

On one PCI slot i plugged in a Deloc dual lpt card. The chip on the card is the: Moschip MCS9815CV
When i start my computer i get following message:
[0.193621] pci 000:05:08: BAR 0 error updating (0x40000008 != 0x000048)
and this for BAR0 to BAR5 wit different adresses.
Afterwards:
modprobe: can´t load module micorcode(kernle/arch/x86/kernle/microcode.ko): No such device

After booting i startet: lspci -v

but the pci i device was not listed.
Non class device
And the memory ???

Can anybody help me?
I don´t know what to do.
Thank you very much

Please Log in or Create an account to join the conversation.

More
10 Sep 2014 21:42 #51031 by ArcEye
Hi

i have installed LinuxCNC with the LiveCD.


Which Live CD? There is the Ubuntu 10.04 one and the Debian Wheezy one

modprobe: can´t load module micorcode(kernle/arch/x86/kernle/microcode.ko): No such device


Look in /lib/modules/{kernel number}/kernel/arch/x86/kernel/

Is microcode.ko really missing?

It rather sounds more like an error with your computer or the card.

Try moving the card to another PCI slot, do you get the same error?

regards
The following user(s) said Thank You: ChrisB

Please Log in or Create an account to join the conversation.

More
11 Sep 2014 03:03 #51046 by ChrisB
HI.
You where right.
The problem is the pci controller on the mainboard.
Thank you for your help.

Please Log in or Create an account to join the conversation.

Time to create page: 0.171 seconds
Powered by Kunena Forum