matrix_kb − Convert integers to HAL pins. Optionally scan a matrix of IO ports to create those integers.
loadrt matrix_kb config=RxCs,RxCs... names=name1,name2...
Creates a component configured for R rows and N columns of matrix keyboard.
If the s option is specified then a set of output rows will be cyclically toggled, and a set of input columns will be scanned.
The names parameter is optional, but if used then the HAL pins and functions will use the specified names rather than the default ones. This can be useful for readbility and 2-pass HAL parsing.
There must be no spaces in the parameter lists.
This component was written to convert matrix keyboard scancodes into HAL pins. However, it might also find uses in converting integers from 0 to N into N HAL pins.
The component can work in two ways, and the HAL pins created vary according to mode.
In the default
mode the component expects to be given a scan code from a
separate driver but could be any integer from any source.
Most typically this will be the keypad scancode from a Mesa
7i73. The default codes for keyup and keydown are based on
the Mesa 7i73 specification with 0x40 indicating a keydown
and 0x80 a keyup event.
If using the 7i73 it is important to match the keypad size
jumpers with the HAL component. Valid configs for the 7i73
are 4x8 and 8x8. Note that the component will only work
properly with the version 12 (0xC) 7i73 firmware. The
firmware version is visible on the component parameters in
HAL.
In the optional scan-generation mode the matrix_kb.N.keycode pin changes to an output pin and a set of output row pins and input column pins are created. These need to be connected to physical inputs and outputs to scan the matrix and return values to HAL. Note the negative-logic parameter described below, this will need to be set on the most common forms of inputs which float high when unconnected.
In both modes a set of HAL output pins are created corresponding to each node of the matrix.
matrix_kb.N
Perform all requested functions. Should be run in a slow thread for effective debouncing.
matrix_kb.N.col-CC-in bit in
The input pin corresponding to column C.
matrix_kb.N.key.rRcC bit out
The pin corresponding to the key at row R column C of the matrix.
matrix_kb.N.keycode unsigned in or out depending on mode.
This pin should be connected to the scancode generator if hardware such as a 7i73 is being used. In this mode it is an input pin. In the internally-generated scanning mode this pin is an output, but will not normally be connected. matrix_kb.N.row-RR-out bit out The row scan drive pins.Should be connected to external hardware pins connected to the keypad.
matrix_kb.N.key_rollover unsigned r/w (default 2)
With most matrix keyboards the scancodes are only unambiguous with 1 or 2 keys pressed. With more keys pressed phantom keystrokes can appear. Some keyboards are optimised to reduce this problem, and some have internal diodes so that any number of keys may be pressed simultaneously. Increase the value of this parameter if such a keyboard is connected, or if phantom keystrokes are more acceptable than only two keys being active at one time.
matrix_kb.N.negative-logic bit r/w (default 1) only in scan mode
When no keys are pressed a typical digital input will float high. The input will then be pulled low by the keypad when the corresponding poll line is low. Set this parameter to 0 if the IO in use requires one row at a time to be high, and a high input corresponds to a button press.