axistest − Used to allow testing of an axis. Used IN PNCconf
|
loadrt axistest [count=N|names=name1[,name2...]] |
axistest.N.update (requires a floating-point thread)
axistest.N.jog-minus bit in
Drive TRUE to jog the axis in its minus direction
axistest.N.jog-plus bit in
Drive TRUE to jog the axis in its positive direction
axistest.N.run bit in
Drive TRUE to run the axis near its current position_fb with a trapezoidal velocity profile
axistest.N.maxvel float in
Maximum velocity
axistest.N.amplitude float in
Approximate amplitude of positions to command during ’run’
axistest.N.dir s32 in
Direction from central point to test: 0 = both, 1 = positive, 2 = negative
axistest.N.position-cmd
float out
axistest.N.position-fb float in
axistest.N.running bit out
axistest.N.run-target float out
axistest.N.run-start float out
axistest.N.run-low float out
axistest.N.run-high float out
axistest.N.pause s32 in (default:
0)
pause time for each end of run in seconds
axistest.N.epsilon
float rw (default: .001)
axistest.N.elapsed float r
Current value of the internal timer
GPL