emc − EMC (The Enhanced Machine Controller)
emc [-v] [-d] [INIFILE]
emc is used to start EMC (The Enhanced Machine Controller). It starts the realtime system and then initializes a number of EMC components (IO, Motion, GUI, HAL, etc). The most important parameter is INIFILE, which specifies the configuration name you would like to run. If INIFILE is not specified, the emc script presents a graphical wizard to let you choose one.
Be a little bit verbose. This causes the script to print information as it works.
Print lots of debug information. All executed commands are echoed to the screen. This mode is useful when something is not working as it should.
The ini file is the main piece of an EMC configuration. It is not the entire configuration; there are various other files that go with it (NML files, HAL files, TBL files, VAR files). It is, however, the most important one, because it is the file that holds the configuration together. It can adjust a lot of parameters itself, but it also tells emc which other files to load and use.
There are several ways to specify which config to use:
absolute path to an ini, e.g.
relative path from the current directory, e.g.
Otherwise, in the case where the INIFILE is not specified, the behavior will depend on whether you configured emc with --enable-run-in-place. If so, the emc config chooser will search only the configs directory in your source tree. If not (or if you are using a packaged version of emc), it may search several directories. The config chooser is currently set to search the path:
Much more information about EMC2 and HAL is available in the EMC2 and HAL User Manuals, found at /usr/share/doc/emc2/.
None known at this time.
This man page written by Alex Joni, as part of the Enhanced Machine Controller (EMC) project.
Report bugs to alex_joni AT users DOT sourceforge DOT net
© 2006 Alex Joni.
This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.